Idiomas disponibles
Idiomas disponibles
BEFORE LOADING YOUR FIRST LOAD OF
LAUNDRY
Your new appliance was tested before leaving
the factory. This process involves running
various wash cycles. As a result, a small
amount of water may remain in the tub and
drainage system. Run a Drum Clean cycle with
no laundry and no detergent to clean the
system before your first load of laundry.
DAILY USE
PREPARING THE LAUNDRY
EMPTY POCKETS
• Coins, paper clips, etc. could damage the
load
and
the
components.
• Tissues will break down during the wash
cycle and the fragments will have to be
subsequently removed by hand.
CLOSE ALL ZIPPERS, BUTTONS, AND
HOOKS. TIE ALL RIBBONS OR BELTS
• Insert the smaller garments (e.g. nylon
hosiery, belts, etc.) and garments with
hooks (e.g. braziers) into a fabric bag or a
pillowcase with zipper. Remove any rings
from curtains, or else place the curtains
inside a fabric bag together with the rings.
FABRIC TYPE/SYMBOL ON THE WASH
LABEL
• Cottons,
mixed
care/synthetics, wool, hand wash items.
• Colour
Separate coloured and white items. Wash
new coloured articles separate.
• Size
Wash items of different sizes in the same
wash load, to improve washing efficiency
and distribution of the articles in the drum.
• Delicates
Wash delicate items separately; they
require gentle treatment.
washing
machine
fibres,
easy
HOW TO USE THE APPLIANCE
1. Load laundry
Open the door and load the laundry. Load
the articles one at a time loosely into the
drum, without overfilling. Observe the load
sizes given in the "Table of wash cycle",
Overloading the machine will result in
unsatisfactory
creased laundry.
2. Close door
Make sure that no laundry gets stuck
between door glass and rubber seal. Close
the door so that you can hear it click shut.
3. Open water tap
Make sure that the appliance is connected
to the water mains. Open the water tap.
4. Set the desired program
Select the required program with WASH
CYCLE SELECTOR knob. The duration of
the wash cycle is shown on the display.
The
washing
displays the default temperature and spin
speed settings possible for the selected
program. Adjust the temperature and/or
spin speed setting if needed with the
relative buttons.
• Change temperature, if needed
Press the TEMP. button to progressively
lower the temperature setting until cold
wash has been set ("－－"will be shown on
the digital display). Pressing the button
again sets the highest possible setting.
• Change spin speed, if needed
Press the SPEED button to progressively
decrease the spin speed until the spin
cycle is turned off ("－－" will be shown on
the digital display). Pressing the button
again sets the highest possible setting.
• Select options, if needed
Press the button(s) to select the option; the
corresponding option indicator light is on.
Press the button(s) again to cancel the
option, the corresponding option indicator
light goes out.
110
washing
results
machine
automatically
and
