Idiomas disponibles
Idiomas disponibles
REMOVING THE TRANSPORT BOLTS
CAUTION
DAMAGE TO THE APPLIANCE OR INJURY
POSSIBLE
• The appliance is secured for transport with
transport bolts. Transport bolts that are not
removed can damage the drum during
operation of the washer, the appliance will
vibrate, and it will be much noisier during
spin cycles if the transport bolts are not
removed before use. Be sure to remove all
4 transport bolts completely before first
use. Keep the transport bolts. If a pedestal
was purchased with the appliance, it must
be installed first, prior to removing the
transport bolts. Please consult the pedestal
installation instructions.
• In order to prevent transport damage
during later transport, be sure to re-install
the bolts before transport.
1. Undo the four transport bolts A by the
wrench (supplied) and remove them.
2. Remove the four spacer tubes B. During
the removal of the bolts occasionally
spacer tubes fall inside the machine, these
can be remove by tilting the machine
forward and recovering them from the floor
or inside the base of the machine.
3. Cover the open transport bolt holes with
the four cover caps C which will find in the
plastic bag containing the accessories.
Keep all the parts in safe place: you will need
them again if the washer needs to be moved
to another location.
NOTE
• Transport the washer for the prevention of
breakage as below:
-
The transport bolts are reinstalled.
-
The power cord is secured to the back
of the washer.
CHOOSING THE RIGHT LOCATION
• Locations requirement
-
The machine should be installed on the
solid and flat floor, never put the
machine on the soft carpet or on the
wood floor. Do not install the machine
on
the
installation location cannot be changed,
the plinth must be improved as
required, such as enlarge the size,
secure with brackets. Never put the
machine on the separate brackets. It is
possible the machine moves a little by
the factors of overloading, situation of
the plinth (wet) and so on, so it will on
risk the machine falls down from the
plinth after working for a period of time.
-
Keep the environment dry and vented.
-
The appliance must be installed and
operated in a room with the drain
-
Never put small appliance, such as
microwave oven; and/or jar cooker, on
the machine.
-
Keep the machine away from the
flaming equipment, such as candle;
cooking stove; liquefied gas container
etc.
-
Never put the pressure containers on
the machine.
-
Never put the machine over the
opening of an uncovered drainage.
95
homemade
plinth,
if
the
