Jocel JLR014085 Manual De Instrucciones página 117

Idiomas disponibles

Idiomas disponibles

Problem
The water level is too low
when the machine is washing
Make up water during wash
cycle operation
There is too much foam in
drum or the foam overflow
from detergent dispenser
The high-speed spinning
needs to be repeated many
times
The machine does not spin
The machine vibrates a lot
during the spin cycle
The spin effect is not ideal.
The machine does not drain ,
drains slow or "E03" appears
in the display
The program time stops
counting down before
entering high-speed spinning
process
The program takes too long
The machine is noisy
This is not a fault. The water consumption in wash cycle of this appliance is
relatively little, the water level in wash cycle is lower than other type washing
machine normally.
If the water level drops, the machine will make up water automatically.
When the amount of washing clothes is too large, the appliance may make up
water automatically several times during wash cycle operation.
The detergent is not suitable for machine washing (it should display the text "for
washing machines" or "hand and machine wash" or the like).
Too much detergent was used – less detergent is required in soft water.
Due to the different types and materials of the laundry, the load balancing system
of the appliance may wobbling and dispersing the clothes for many times to
prolong the spinning time. This is a normal phenomenon, not a machine failure.
The Spin Speed is turn off by pressing the SPEED button to set all spinning speed
value indicator light go out on the display.
The feet have not been adjusted, enabling the machine to rock.
New Installation – Either the Transit Bolts including the plastic spacer, or the
Polystyrene Packaging have not been removed when installing the machine.
The appliance is trapped between cabinets and/or walls.
The load is in a slight out of balance condition and the appliance is spinning, but
at a lower speed.
When washing less clothes, such as a pair of jeans, a sweater, a bath towel, etc.,
the machine may not complete the spinning process due to balance protection.
If the load is in a slight out of balance condition and the appliance is spinning, but
at a lower speed, not at the default spin speed of the cycle or the spin speed setting
for the cycle.
The top of the drain hose is too high – It must be fitted at a height between 65 and
100 cm from the floor。
The pump filter is blocked.
The drain hose is kinked , twisted or bended.
The drain hose is blocked or frozen.
This is not a fault. The load balancing system of the appliance wobbling and
dispersing the clothes in the drum for a long time to achieve balance and complete
high-speed spinning; In the process of wobbling and dispersing, the program time
stops counting down before the appliance entering high-speed spinning process.
Program times will vary due to water pressure, the incoming water
temperature and if the wash load goes out of balance. This will increase the
program times accordingly (see "The high-speed spinning needs to be repeated
many times" ).
There will always be some motor, pump and drum noise during spin.
The washing machine touches other objects.
The foreign matters such as hairpins or metal objects fall in drum or tub.
Possible cause / solutions
117
loading