Idiomas disponibles
Idiomas disponibles
!If the selected option is incompatible with the
program set, the incompatibility will be
signaled by a buzzer and the corresponding
option indicator light will flash.
!If the selected option is incompatible with
another previously set option, only the most
recent selection will remain active.
5. Add detergent
Pull out the detergent dispenser and add
detergent (and additives/softener) into the
relative compartments as described below.
Compartment 1:
Powder washing
detergent
Compartment 2:
Liquid washing detergent
The liquid detergent must
not exceed the "MAX" level.
Compartment 3:
Additives (Softener. etc.) The fabric softener
must not exceed the "MAX" level.
Observe the dosing recommendations on the
detergent pack.
Correct dosing of detergent/additives is
important, because:
• It optimizes the cleaning result.
• It avoids irritating residues of surplus
detergent in your laundry.
• It saves money by avoiding waste of
surplus detergent.
• It
protects
the
calcification of components.
• It respects the environment by avoiding
unnecessary environmental burden.
! Do not use hand washing detergents
because these create too much foam.
washer
by
avoiding
!Use powder detergent for white cotton
garments, for pre-washing, and for washing at
temperatures
over 60℃.
! Follow the instructions given on the detergent
packing.
6. Delaying the end of a program
• To set a program to end at a later time, see
the section "Control panel / DELAY END".
7. Start program
• Press the START/PAUSE
relative indicator light is lit, the door locks
and the DOOR LOCK indicator light is lit.
• To avoid overflow, do not open the
detergent dispenser during a running
program anymore.
• The remaining program duration can vary.
Factors like unbalance in the wash load, or
foam formation, can have an effect on the
program duration.
8. Change the settings of a running
program, if needed
You can still change the settings while a
program is running. The changes will be
applied, provided the respective program
phase has no finished yet.
To change the settings of a running
program:
• Press START/PAUSE
running program on pause.
• Change your settings.
• Press START/PAUSE
continue the program.
If you have changed the program, do not add
detergent for the new program.
To prevent that a running program is changed
by accident (for instance by children), use the
CHILD LOCK function (see section "Control
panel / SPEED").
111
button. The
button put the
button again to
