Idiomas disponibles
Idiomas disponibles
Troubleshooting
WARNING
Repairs to electrical appliances should only be carried out by specialists
trained by the manufacturer. Improper repairs can cause considerable risks
to users and damage to the appliance.
Fault
The appliance is
not working.
The appliance
does not produce
any/produces too
little steam.
Water drips out
of the sole of the
iron
.
Wet areas occur
on the goods be-
ing ironed.
NOTE
►
If you are unable to resolve the problem by taking any of the aforemen-
tioned steps, please contact the service department.
SDBS 2400 A1
Possible cause
Voltage supply error.
The appliance is not switched on. Switch the appliance on using
There is not enough water in the
water tank
.
The appliance has not heated up
sufficiently.
The temperature control
been set in the
range.
The steam unit has not been used
for a long time or is being used
for the first time.
If steam ironing is paused briefly,
the cooling steam condenses
in the connecting hose
leads to drip formation.
The temperature you have set is
too low for steam ironing.
Such areas can be caused by
steam condensing on the ironing
board.
Remedy
Ensure that the plug is firmly
inserted into the power socket.
the On/Off button
Fill the water tank with water
Wait until the temperature indica-
tor lamp goes out.
Turn the control until a temperature
has
in the
–
Press and hold down the steam
button. The steam takes a little
time until it discharges from the
sole of the iron
This is normal. Hold the iron over
a collecting cloth or container
. This
and press the steam button
Steam will discharge from the
sole of the iron
water after a few seconds. You
can now continue ironing.
Set a temperature suitable for
steam ironing (setting range
First, wipe any wet areas off
the ironing board and then iron
the wet areas on the fabric dry
without steam.
.
.
range has been set.
.
.
instead of
).
GB │ IE
39
■
│
