Idiomas disponibles
Idiomas disponibles
Operation
Q
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
when the product is in operation.
Setting the cutting depth
Q
NOTE
Select a cutting depth of approx. 3 mm more
u
than the thickness of the material for a clean
cut.
1.
Loosen the locking lever
cutting depth on the cutting depth scale
and then retighten the locking lever
Switching on and off
Q
Switching on:
1.
Push the safety interlock
and keep it pressed.
2.
Press the on / off switch
safety interlock
1
NOTE
The LED work light
u
on / off switch
2
the work area in low lighting condition.
Switching off:
1.
Release the on / off switch
product off.
NOTE
The LED work light
u
10 seconds after the product has been
switched off.
Cutting
Q
WARNING!
During operation fine dust will be generated!
u
Some dusts are highly inflammable and
explosive! Do not smoke during operation,
keep heat sources and open flames out of
the working area! Always wear a dust mask
to protect yourself against hazards resulting
from fine dust.
32 GB / IE
5
, set the desired
3
.
5
to the left or right
1
2
. Release the
once the product is running.
11
lights up when the
is depressed. It illuminates
to switch the
2
remains on for about
11
Avoid damaging the cutting edge of sensitive
o
materials, e.g. coated chip boards or doors,
by sticking masking tape along the cutting
line. Another benefit of this is that it is easier
to mark a line on the tape than on a shiny
surface. An even more effective method of
protecting the cutting edges is to clamp a
thin piece of wood along the cutting line (this
wood is also sawn).
Cut in the direction of the wood grain
o
whenever possible to avoid jamming the saw
blade and fraying edges.
Take the cutting edge into consideration when
o
cutting along marked cutting lines. Do not cut
directly on the line but next to it.
Ensure the workpiece is free of obstacles like
o
nails or screws before operation. Remove
them if required.
Ensure that there is sufficient clearance for the
o
saw blade under the workpiece.
Never hold the workpiece with your hands or
o
across your leg. Secure the workpiece with
proper clamps to a stable worktop. Support
longer workpieces to avoid tilting.
Hold the product firmly with both hands
o
on main and auxiliary handle. Never try to
operate the product with only one hand!
Keep your hands away from under the
workpiece.
Switch the product on and wait until it runs at
o
full speed before placing it on the workpiece.
Carefully lead the product to the workpiece.
o
Place the front of the base plate flat on the
workpiece and push the product forward at
an even speed.
Only apply as much pressure as necessary
o
to keep the product flat on the workpiece.
Higher pressure will not increase but lower
the performance of the product and leads to
uneven results.
Keep the product moving at all times, do not
o
stop in one position to avoid grooves.
Lift the product from the workpiece before
o
switching it off.
1.
Switch on the product (see "Switching on and
off") and then place it with the front edge of
the base plate
6
2.
Align the product using the rip fence
using a marked line.
3.
Hold the product in both hands using the
handles and cut by exerting an even pressure.
on the material.
or by
14
