Work - IPC Gansow Ct100 Manual De Instrucciones

Always empty the recovery tank before refilling the solution tank.
For an effective cleaning and long life of the equipment, it is necessary to follow some
simple rules:
• prepare the work area, keeping away the possible obstacles;
• begin to work starting from the farthest spot, in order to avoid trampling on the area
just-cleaned;
• choose paths that are as much straight as possible;
• on wide floors divide the paths into rectangular and parallel areas.
At the end quickly mop the area, if necessary, to clean spots that are inaccessible to the
scrubber.
6.7

Work

After setting up the machine, proceed as follows:
• insert and operate the key to release the main switch (fig. 8, ref. 2) and enable all the
machine functions: the battery charge level indicator will come on (fig. 8, ref. 9);
• move the cock lever (fig. 8, ref. 3) to the position of minimum flow of solution: the
detergent solution begins to reach the brushes;
• press the brush/roller up-down button (fig. 8, ref. 5) on the arrow down: the head will
begin to move down and as soon as the brushes touch the floor the brush motors will
come on. As the brushes rotate, the solution is distributed over the floor;
• lower the squeegee by means of the proper lever (fig. 8, ref. 11): the suction motor
comes on;
• press the drive lever (fig. 8, ref. 6) placed under the handgrip: the drive motor is started
and the machine starts moving forward;
• adjust the running speed via the potentiometer (fig. 8, ref. 1);
• if you wish to engage reverse gear during work with the squeegee lowered, you must
first stop and raise the squeegee;
• check periodically that the detergent solution reaches the brushes/rollers and fill with
solution if it runs out;
• check cleaning quality during work and adjust, as required, the flow of solution sent to
the brushes/rollers (by rotating the cursor (fig. 8, ref. 3)) and the pressure exerted by
the head-brushes on the floor (via the brush up-down button (fig. 8, ref. 5) until the test
pressure indicator (fig. 8, ref. 8) indicates the required level).
In working conditions, if the emergency switch is accidentally pressed and the
machine is switched off, when it is switched on again the brush button must be
Never leave the machine stationary with the head lowered and the brushes in
Whenever you fill up the solution tank, always empty the recovery tank.
Do not leave the machine stationary with the suction motor on and the solution
• if the warning led (fig. 8, ref. 9) starts flashing, it means that the storage batteries are
getting flat. Therefore, it is necessary to recharge them; if you keep on working, the
batteries could become damaged irreparably;
• if the suction unit revs up but does not perform suction, it means that the floater has
cut in. In this case the recovery tank must be emptied (see specific paragraph).
ENGLISH
16
familiarity.
i INFORMATION
pressed to re-activate the brushes.
WARNING
motion: the floor could be damaged.
WARNING
cock turned on.