Pulsar THERMION XM38 Guia De Inicio Rapido página 7

• Attach the second plug of the USB cable (16) to the USB port on the mains
adapter (17).
• The LED indicator (15) will display the battery charge status (see Table).
* Included in the delivery package. The use of a
rechargeable APS3 Battery Pack is possible.
** Available separately.
LED Battery charge status
Indicator *
Battery charge from 0 to 10%.
Charger not connected to the
mains power supply.
Battery charge from 0 to 10%.
Charger connected to the mains
power supply.
Battery defective.
Battery should not be used.
Battery charge from 10 to 20%.
Battery charge from 20 to 60%.
Battery charge from 60 to 95%.
Battery completely charged.
Can be disconnected from the
charger.
* The LED indicator displays the current level
of charge of the battery for 30 seconds
when the APS charger is not plugged in.
When the power is connected, the display
shows the current status of the battery constantly, the LEDs additionally
flickering to indicate the battery charging process.
Installing the removable battery
• Turn the battery cover (7) counter clockwise and
remove.
• Install the battery (8) into the battery compartment
along the special guides in the device casing
designed for it.
• When properly installed, the battery is locked into the
slot with a special clip.
• Replace the battery compartment cover (7),
turning it clockwise.
А
8
А
B
15
LED Indicator
18 17
Power Charger
outlet
Battery
slot cap
8
Battery
ENGLISH
Battery
Charging
13
base
B
Micro-USB
port
14
16
USB
cable
7
4