Hilti TE 700-AVR Manual Del Usuario página 14

5.2 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
1. Slide the side handle clamping band over the chuck from the front and
into the recess provided.
2. Bring the side handle into the desired position.
3. Secure the side handle by turning the knob until the clamping band is
tight.
5.3 Fitting the accessory tool
WARNING
Risk of injury! The accessory tool gets hot during use and may also
have sharp edges.
▶ Wear protective gloves when changing the tool.
DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable
materials.
Note
Check the accessory tool for damage or uneven wear each time before
use and replace it if necessary.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable
grease may cause damage to the product.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go, turning it and
applying light pressure until it engages with an audible click.
◁ The product is ready for use.
Note
Use only the recommended grease supplied by Hilti. Use of unsuit-
able grease may cause damage to the product.
8 English
Printed: 02.02.2017 | Doc-Nr: PUB / 5071172 / 000 / 05
2
3