Idiomas disponibles
Idiomas disponibles
• Place the lava rocks on the burner and around the burner evenly, then tight. Put on top of the
lava rocks the 3 pcs of decorative wooden. (See the pictures 10 and 11)
(Picture 10)
Warning: Lava rocks can't cover the ignition hook.
• Unscrew the button cap of ignite, put a piece of AAA (not supplied) battery into ignite
compartment with anode outward, then screw the button cap (see picture 12)
INSTRUCTION FOR CONNECTING GAS CIRCUIT TO LPG CYLINDER:
Keep at hand suitable crossed screwdriver, adjustable spanners, pliers and wrenches. Before
assembly, make sure all protection packing material has been removed. You need to purchase one
gas regulator and one gas cylinder. The gas regulator has to be set according to National Rules in
force for specific gas category (see on page 2) and proper gas consumption (g/h) specification. The
LPG cylinder should be standard one. Recommend to use 15kg. Replacement must be that
specified in "Gas Requirements" section of this Instruction Manual. Be careful: do not kink flexible
gas rubber pipe of gas circuit. If pipe holder should not be provided, thread of the gas inlet
connection will be in line with Standards ISO 7-1 or ISO 228-1, according to National Rules in force
of the country of destination.
• Make sure appliance gas knob is turned "OFF" before assembling (see below Figure).
• Position the LPG cylinder at the side of your appliance, not underneath, keeping in mind that the
LPG cylinder must be kept away from heat and in a safe position.
• Connect the regulator to LPG cylinder by hand
• Connect the hose to the appliance and the regulator. Tighten the screw of the hose clamp with
a screwdriver.
(Picture 12)
36
(Picture 11)
