Idiomas disponibles
Idiomas disponibles
EN
up the power tool or pull the plug out of the socket. Keep the
power cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled power cords increase the risk of an
electric shock.
•
Keep power tools away from rain or moisture. Water
penetrating into a power tool increases the risk of an electric
shock.
•
If the power tool must be used in a moist environment, use
a ground fault circuit interrupter. Using a residual current
operated circuit-breaker avoids the risk of electric shock.
•
Only use suitable extension cables that are fully intact. A
harmonised H05RR-F 3 x 1.0sq mm rubber type cord is
required as a minimum for general use.
•
Always disconnect the Heat Gun from the power supply
when not in use.
•
Store the heat gun in a dry location out of the reach of
children.
•
Keep your workplace clean and well lit.
•
Do not over-reach, especially when working on ladders.
•
Never use to thaw frozen pipes located inside walls or near
combustibles.
MAINS CONNECTION (UK only)
This Heat Gun has been supplied with a fused cordset. This is
identified by the fuse holder in the base of the plug. Please read
the following safety instructions before use:
1. If the cordset is damaged replace with a new cordset to avoid
a safety hazard. Please contact Wagner customer services for
4
a replacement cordset.
2. NEVER under any circumstances use the Heat Gun or cordset
without the fuse cover fitted. This is the little cover fixed into
the base of plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical
dealer for a replacement or ring our helpline.
4. A replacement fuse must be rated at 13 Amps. This must be
manufactured and approved to BS1362.
5. IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED
ELECTRICIAN
MAINS CONNECTION (Non-UK)
This Heat Gun has been supplied with a cordset. If the cordset
is damaged replace with a new cordset to avoid a safety hazard.
Please contact Wagner customer services for a replacement
cordset.
IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED
ELECTRICIAN
WARNING - Use an extension cord that will accept the plug on
the product. Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one heavy enough
to carry the current your product will draw. An undersized cord
will cause a drop in line voltage resulting in loss of power and
overheating. A harmonised H05RR-F 3 x 1.0sq mm rubber type
cord is required as a minimum for general use.
FURNO 300
