Idiomas disponibles
Idiomas disponibles
50
BODE FREQUENCY SHIFTER 1630
(PL) Krok 2: Sterowanica
12-BOLCOWY PANEL TESTOWY
Bode 1630 posiada panel testowy z dwunastoma bolcami na dole głównej płytki
drukowanej, po prawej stronie. Układ jest następujący:
Bolec
1
Uziemienie
3
Zmienny Osc – wyjście
5
Stały Osc 2 – wyjście
7
Filtr BFO 2 – wyjście
9
Filtr Bode 1 – wyjście
11
Mnożnik 1 – wyjście
Zalecane jest pozostawienie zworki wytłumienia na miejscu, jeśli jej wyjęcie nie
jest absolutnie konieczne.
Bolec
2
Włącz wytłumienie
4
Stały Osc 1 – wyjście
6
Filtr BFO 1 – wyjście
8
Uziemienie
10
Filtr Bode 2 – wyjście
12
Mnożnik 2 – wyjście
Power Connection
(EN)
P1
Red Stripe
2
1
10
9
200 mm ± 10
Connect end P1 to the module socket
Connect end P2 to the power supply
The module comes with the required power cable for connecting to a standard
Eurorack power supply system. Follow these steps to connect power to the
module. It is easier to make these connections before the module has been
mounted into a rack case.
1. Turn the power supply or rack case power off and disconnect the power cable.
2. Insert the 16-pin connector on the power cable into the socket on the power
supply or rack case. The connector has a tab that will align with the gap in the
socket, so it cannot be inserted incorrectly. If the power supply does not have a
keyed socket, be sure to orient pin 1 (-12 V) with the red stripe on the cable.
3. Insert the 10-pin connector into the socket on the back of the module. The
connector has a tab that will align with the socket for correct orientation.
4. After both ends of the power cable have been securely attached, you may
mount the module in a case and turn on the power supply.
Installation
The necessary screws are included with the module for mounting in a Eurorack
case. Connect the power cable before mounting.
Depending on the rack case, there may be a series of fixed holes spaced 2 HP apart
along the length of the case, or a track that allows individual threaded plates to
slide along the length of the case. The free-moving threaded plates allow precise
positioning of the module, but each plate should be positioned in the approximate
relation to the mounting holes in your module before attaching the screws.
Hold the module against the Eurorack rails so that each of the mounting holes
are aligned with a threaded rail or threaded plate. Attach the screws part way to
start, which will allow small adjustments to the positioning while you get them all
aligned. After the final position has been established, tighten the screws down.
Quick Start Guide
P2
1
2
HOT USED
15
16
+ 12V
+ 12V
GROUND
GROUND
- 12V
- 12V
51
