Idiomas disponibles
Idiomas disponibles
• Do not place the product near interference fields, metal frames,
computers, TVs, etc. Electronic devices and window frames can
negatively affect the product's functionality.
• Do not drop the product and do not expose it to any major
shocks.
• Keep the packaging material out of the reach of children due to
the risk of suffocation.
• Dispose of packaging material immediately in accordance with
the locally applicable regulations.
• Do not modify the product in any way. Doing so voids the
warranty.
• Use the product only for the intended purpose.
• As with all electrical products, this device should be kept out of
the reach of children.
• Only use the article under moderate climatic conditions.
• The product is intended only for use inside buildings.
• Route all cables so that there is no risk of tripping.
• Do not bend or crush the cable.
• Always pull directly on the plug when disconnecting the cable,
never on the cable itself.
Warning - Batteries
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do so
could result in the batteries leaking or exploding.
• Only use batteries that match the specified type. Keep the
instructions for the correct choice of batteries included with
the operating instructions of devices safe for future reference.
• Before you insert the batteries, clean the battery contacts and
the polarity contacts.
• Do not allow children to change batteries without supervision.
• Replace all the batteries in a set at the same time.
• Do not mix old and new batteries, or batteries of different
types or from different manufacturers.
• Remove the batteries from products that are not being used
for an extended period (unless these are being kept ready for
an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries or heat them up.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Remove spent batteries from the product and dispose of them
without delay.
• Avoid storing, charging and using in extreme temperatures
and at extremely low atmospheric pressures (such as at high
altitudes).
• Ensure that batteries with damaged housings do not come
into contact with water.
• Keep batteries out of the reach of children.
Risk of electric shock
• Do not open the device or continue to operate it if it becomes
damaged.
• Do not use the product if the
AC adapter, the adapter cable or the mains cable are
damaged.
• Do not attempt to service or repair the product yourself. Leave
any and all service work to qualified experts.
5. Commissioning
Warning
• Only operate the product from an approved socket that is
connected to the public power supply. The socket must be
installed close to the product and must be easily accessible.
• Disconnect the product from the power supply using the On/
Off switch – if this is not available, unplug the power cord
from the socket.
• If using a multi-socket power strip, make sure that the total
power consumption of all connected devices does not exceed
the socket strip's maximum throughput rating.
• If you will not be using the product for a prolonged period,
disconnect it from mains power.
5.1 Inserting batteries / power supply
Measuring station
• Remove the protective film from the display.
• Open the battery compartment (38) and remove the contact
breaker.
• Then close the battery compartment cover.
Note
Please remember, during commissioning, to always insert the
batteries into the measuring station first.
Base station
• Remove the protective film from the display.
• Then connect the enclosed power supply unit to the power
supply unit connection socket on the side (30).
• Connect the weather station's power supply unit to a correctly
installed mains socket.
• Alternatively, you can also insert 2 x AA batteries. However the
display switches to unilluminated standby mode after 10 seconds
with battery operation.
5.2 Changing batteries
Measuring station
• If the battery warning symbol
ambient humidity, replace the batteries in the measuring station
with two new batteries.
(16) appears next to the outdoor
5
