Craftsman LT 2000 Manual Del Usuario página 25

IMPORTANT: The V-belt found on your tractor is specially designed
to engage and disengage safely. A substitute (non-OEM) V-belt can
be dangerous by not disengaging completely. For a proper working
machine, use identical equipment belts as listed in the parts pages of
this Operator's Manual.
To change or replace the deck belt on your tractor, proceed as follows:
1. Remove the deck as instructed earlier in this section.
2. Remove the belt covers from the spindle pulleys by removing the
hex screws that fasten the covers to the deck. See Fig. 23.
3. Loosen the hex nuts on the deck idler pulleys to get the belt off
(and on) the pulleys and around the belt guards. After loosening
the deck idler pulleys, rotate the belt guide out of the way on the
right idler pulley to remove (and reinstall) the belt.
4. Carefully remove the deck belt from around the two spindle
pulleys and the two deck idler pulleys. See Fig. 23.
5. To place the new belt, begin by routing the belt around the two
outer spindle pulleys as shown in Fig. 23.
6. Then route the belt around the two deck idler pulleys as shown in
Fig. 23.
7. Retighten the belt keeper rod loosened earlier.
8. Remount the belt guards removed earlier.
9. Re-install the deck, making sure the belt remains routed around
the pulleys as instructed. The complete belt routing is shown in
Fig. 23.
10. Pull the right side of the belt, and place the narrow V side of the
belt into the PTO pulley.
11. While holding the belt and pulley together, rotate the pulley to the left.
Continue holding and rotating the pulley and belt until the belt is
fully rolled into the PTO pulley.
SERVICE AND MAINTENANCE
Hex Washer Screws
Belt Guard
PARKING BRAKE ADJUSTMENT
Never attempt to adjust the brakes while the engine is running. Always
disengage PTO (Blade Engage Lever), move shift lever into neutral
position, stop engine and remove key to prevent unintended starting.
If the tractor does not come to a complete stop when the clutch-brake
pedal is completely depressed, or if the tractor's rear wheels can roll with the parking brake applied, the brake is in need of adjustment.
Contact the nearest Parts & Repair Service Center to have your
brakes serviced.
To locate the nearest Parts & Repair Service Center or to schedule
service, contact 1-800-4-MY-HOME®.
CHANGING THE TRANSMISSION DRIVE
BELT
NOTE: Several components must be removed and special tools (i.e.
air/impact wrench) in order to change the tractor's drive belt. Contact
the nearest Parts & Repair Service Center to have your transmis-
sion drive belt serviced.
To locate the nearest Parts & Repair Service Center or to schedule
service, contact 1-800-4-MY-HOME®.
Spindle Pulley
Belt Cover
Belt Guide
Deck Idler Pulley
Figure 23
25
WARNING
This portion of the
belt routes around
the PTO Pulley