Idiomas disponibles
Idiomas disponibles
4. Mount the M6 adapter on the parallel guide (3).
▶ The M6 adapter engages.
5. Push the parallel guide into the mounting adapter until it engages with an audible click.
5.8
Changing the cutting blades
You can use a set of cutting blades 2× by swapping over the cutting blade on the moving cutting arm
with the cutting blade on the stationary cutting arm.
Removing cutting edges
1. Set the function selector switch to the
2. Move the cutting arm until the securing screw is readily accessible.
3. Set the function selector switch to the
4. Remove the depth gauge by pressing and holding down the release button and pulling out the depth
gauge.
5. Use the hex key to slacken the securing screw in the movable cutting arm.
6. Remove the cutting edge from the movable cutting arm.
7. Use the hex key to slacken the securing screw in the stationary cutting arm.
8. Remove the cutting edge from the stationary cutting arm.
Installing cutting blades
9. Remove the cutting edges. → page 24
10. Check the set of cutting edges for burrs on the cutting sections and, if necessary, remove the burrs with
a file.
11. Check the orientation of the arrow marks and insert the cutting blade into the stationary cutting arm.
▶ The arrow mark faces toward the middle.
▶ The securing screw can be screwed in easily.
12. Secure the cutting blade to the stationary cutting arm with the securing screw.
13. Check the orientation of the arrow marks and insert the cutting blade on the movable cutting arm.
▶ The arrow mark faces toward the middle.
▶ The securing screw can be screwed in easily.
14. Secure the cutting blade to the movable cutting arm with the securing screw.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Notes on formation of burrs at the cut
Burrs on the cut length of threaded rod rarely form on the side close to the movable cutting arm. On account
of the design of the product, burrs on the cut length of threaded rod tend to form more frequently on the
side close to the stationary cutting arm.
Burrs can also form if:
•
The threaded rod is not seated correctly in the thread of the cutting blades.
•
The cutting blades are in poor condition → page 26.
•
The thread of the threaded rod is uneven.
•
The securing screws of the cutting blades are not correctly tightened.
If a nut cannot be threaded on to the rod because of a burr remove the burr, for example with a pair of
nippers, a file or an adjustable threading die.
6.2
Measuring threaded rod 6,
WARNING
Risk of injury if the power tool falls! Lifting or carrying the power tool by unsuitable parts could bend or
break these parts and allow the power tool to fall.
▶ Lift and carry the power tool only by the main grip or by the housing, or in its case. Attached parts such
as scaffold hook, depth gauge or container are not designed for transport purposes.
24
English
4
function.
function and remove the battery.
7
2362838
*2362838*
