Idiomas disponibles
Idiomas disponibles
Appendix: Hilti Foundation Fastening Kit
Hilti HVA: HVU M12x110 + HAS-R M12x110/168
Installation guide
1. Produce a hole with a hammer drill:
– Diameter: 14 mm
– Drilling depth: 110 mm
1
TIP: Use a Hilti hollow drill bit type TE-CD or TE-YD
with Hilti vacuum connection.
2. Clean the drill hole: Blow out coarse dust until the
exiting air is dust-free.
2
4x
– With a hand pump: Using the Hilti blow-out
pump, blow out the drill hole from the base
of the hole at least 4 times.
– Compressed air cleaning (CAC): Blow out the
drill hole twice with oil-free compressed air,
from the base of the hole through its entire
3
length (min. 6 bar at 6 m
/h; use an extension
if necessary).
Information
Before inserting the pin, make sure the hole is free
from drilling dust and other impurities.
Poorly cleaned drill hole = low load-bearing capacity
3. Check the correct hole depth of 110 mm with the
aid of the marking on the anchor rod:
– The drill hole must not be deeper than the
embedment depth.
– If the embedment depth is inadequate, make
the drill hole deeper.
3
4. Insert the Hilti HVU anchor capsule (with plastic
bag) fully into the drill hole.
1 4
HVU
HVU
Appendix: Hilti Foundation Fastening Kit
5. Screw the anchor rod into the anchor capsule
with the embedment tool under moderate
pressure, with the drill's hammer function
switched on (250 – 1000 rpm).
When the marked embedment depth is reached,
switch off the hammer drill.
1 5
HAS
HAS
HIS
HIS
6. Do not move the anchor rod during the curing
time t
.
rel
1 6
t
t
rel
rel
DE
EN
ES
FR
IT
JP
KO
NL
PTB
RU
ZH
ZHT
23
