Idiomas disponibles
Idiomas disponibles
GB
3. Set the mower mechanism to the maximum
cutting height (06/2).
4. Engage the mower mechanism using the tog-
gle switch (02/5, position "1").
5. Set the required cutting height using the hand
lever (06/2).
6. Set the lawn tractor in motion.
7.5.5.2
Mowing in reverse
NOTE The mower mechanism is switched
off if just the reverse transmission pedal is
pressed.
1. Press the "Reverse mowing" button (02/6)
and, within 5 seconds, press the pedal for re-
verse driving (04/1).
WARNING! There is an accident risk
when reverse mowing! Pay attention to the area
behind you when mowing in reverse! Only mow
in reverse when it is necessary to do so!
7.5.5.3
Switching off the mower mechanism
WARNING! Danger due to spinning
blades! When the cutting blades are still spin-
ning, they can cause laceration injuries to hands
and feet! As a result, keep your hands and feet
away from the cutters!
1. Disengage the mower mechanism using the
toggle switch (02/5, position "0").
The mower mechanism can be switched off when
the tractor is at a standstill and when it is being
driven.
WARNING! Risk of injury due to objects
being thrown out! When crossing areas of grav-
el and crushed stone, objects can be drawn into
the running mower mechanism and then thrown
out.
■
Always switch off the mower mechanism if
you are driving over surfaces other than
lawns.
7.5.5.4
Emptying the grass catcher
NOTE An audible signal sounds when the
grass catcher is full. The catcher should be emp-
tied now if not before.
Depending on the equipment variant, your lawn
tractor has electrically operated grass catcher
emptying or a manually operated grass catcher
with operating lever.
42
The following applies to all catcher types:
■
The grass catcher can be emptied from the
operator's seat.
■
The engine cuts out if the grass catcher is lift-
ed up or disconnected when the mower
mechanism is switched on.
■
The mower mechanism cannot be switched
on unless the grass catcher is engaged cor-
rectly.
Emptying the electrically operated grass
catcher
1. For emptying, operate the toggle switch
(07/1) on the left of the operator's seat.
2. To close the grass catcher, operate the tog-
gle switch again.
Emptying the grass catcher with operating
lever
1. Pull the operating lever out of the grass
catcher (17/a).
2. Push the lever in the driving direction so the
grass catcher opens (17/b).
3. Move the grass catcher backwards with the
lever until the catcher engages.
7.5.5.5
Mulching
For optimum mulching results, the grass should
be mowed on a regular basis (approx. 1 or 2
times per week). When doing so, cut 1/3 of the
grass height (e.g. if grass height is 6 cm, mow
2 cm). This will ensure that the mown grass will
be properly intermixed in the remaining grass.
7.5.5.6
Mowing interval
Please take into account that grass grows differ-
ently at different times. We recommend using a
shorter interval between mowing during early
spring. You can increase the mowing intervals as
the growth rate of the grass begins to decline
during the course of the year.
If you are unable to mow the grass for an extend-
ed period, you should initially select a higher cut-
ting height setting, then re-mow two days later
with a lower cutting height setting.
7.5.5.7
Mowing high grass
Mow with a higher cutting height adjustment
when the grass is longer than normal or when it
is wet. Then re-mow the grass with a lower, nor-
mal setting.
7.5.5.8
Cutting blade maintenance
Make sure that the cutting blade remains sharp
for the entire mowing season to avoid shredding
Operating the tractor
493723_a
