Idiomas disponibles
Idiomas disponibles
RIP FENCE
Attach the handle to the fence cam.
The Rip Fence
slides onto the rear fence rail so that the hook is under the rear rail and rides on the front Fence Guide. The fence
PC24
locks in place by applying pressure in a downward motion on the Rip Fence Handle
to using your saw. To check alignment of the rip fence, see alignment instructions on page 29.
MITER GAUGE
Insert Miter Gauge
into each miter slot to make sure it slides freely. See Adjusting the Miter Stops section on page 28 for
PC6
adjustment of miter gauge accuracy.
ON-BOARD STORAGE
The Delta #36-5000 T2 series contractor table saws comes with on-board storage for the provided Miter Gauge
Blade Wrench
, Push Stick
PC9
gauge, spare blade and blade wrench storage areas are located on the right side panel of the machine and come pre-installed.
On-board storage for the rip fence and the push stick is located on the left side of the saw.
SECURING SAW TO FLOOR
This saw is designed for portability. DO NOT attempt to use the saw to cut a large or cumbersome workpiece
without first taking appropriate steps to protect against tipping the saw. Examples of appropriate steps include the use of support
tables and/or securing the saw legs to the floor by replacing the saw feet with connecting bolts or by attaching the legs to a floor
mounted bracket with u-straps.
ASSEMBLY
and Rip Fence
. There is also on-board storage for spare saw blades (sold separately). The miter
PC7
PC4
. Rip fence alignment should be checked prior
PC15
25
, Riving Knife,
PC6
