ABB ACS580-04 Guía Rápida De Instalación Y Puesta En Marcha página 17

4.
The Home view monitors the val-
ues of selected signals.
Motor overload protection
￭
Motor overload protection is not enabled by default. Motor overload protection can
be measured or estimated in one of the following ways: 1) using motor temperature
devices, 2) using a motor model defined by parameters, or 3) using motor current and
motor class curves. To enable protection using motor temperature devices or motor
model parameters, set parameter 35.11 and subsequent parameters through 35.55.
To adjust motor class curves (default is class 20), change parameters 35.56 and 35.57.
Use the information key (
group 35 parameters. You must set the drive overload parameters correctly, or motor
damage can occur.
Fieldbus communication
￭
To configure the embedded fieldbus communication for BACnet MSTP, you must set
at least these parameters:
Parameter Setting
20.01 Ext1 commands Embedded fieldbus
22.11 Speed ref1 source EFB ref1
26.11 Torque ref1 source EFB ref1
28.11 Frequency ref1 EFB ref1
source
58.01 Protocol enable BACnet MSTP
EN – Quick installation and start-up instructions 17
5.
Make additional adjustments
starting from the Main menu.
Press (Menu) in the Home
view to enter the Main menu, and
select Primary settings and press
(Select).
?
) on the drive control panel for more information on setting
Description
Selects fieldbus as the source for the start and stop
commands when EXT1 is selected as the active control
location.
Selects a reference received through the embedded
fieldbus interface as speed reference 1.
Selects a reference received through the embedded
fieldbus interface as torque reference 1.
Selects a reference received through the embedded
fieldbus interface as frequency reference 1.
Initializes embedded fieldbus communication.
6.
To get more information on the
Primary settings menu items,
?
press to open the help page.
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
SV
TR
ZH