Idiomas disponibles
Idiomas disponibles
LSF12 S400-2
Correct working with the die grinder
Read the Section Safety instructions before using the
die grinder.
T
WARNING Failure to follow correct working
practices can result in serious injury or death
Ensure that the workpiece is properly supported
►
Ensure that sparks do not cause a hazard to people
►
or materials
There is a risk of electrostatic discharge if the tool
►
is used on plastic and other non-conductive mater-
ials
Personal protective equipment must be used as
►
described in Section Personal protective equip-
ment
Slip/Trip/Fall is a major cause of serious injury
►
or death. Watch out for excess hose left on the
walking or work surface
Proceed with care in unfamiliar surroundings.
►
Hidden hazards may exist, such as electric or
other utility lines
Maintain a balanced body position and firm foot-
►
ing
React quickly to excessive vibration due to dam-
►
aged, or improperly mounted insert tool
Keep away from rotating drive spindle and abras-
►
ives. Rotation may continue for several seconds
after the throttle has been released. Do not lay the
tool down until rotation has stopped
Observe that stored compressed air in the hose
►
may cause an accidental start
Release control device if the energy supply should
►
fail
Maintenance
Rust protection and internal cleaning
Water in the compressed air, dust and wear particles
cause rust and sticking of vanes, valves etc.
This can be solved by lubricating with oil (a few
drops), running the machine for 5-10 seconds and
EN
© Atlas Copco Industrial Technique AB - 9836 5656 00
Safety and operating instructions
wiping off excess oil with a cloth. Do this before
longer standstills.
Lubricating guide
Use lubricants of good quality. The oils and greases
listed in the lubrication table are examples of lubric-
ants that can be recommended.
Brand
General purpose
Bearings
BP
Energrease LS-EP2
Castrol
Spheerol EP L2
Esso
Beacon EP2
Q8
Rembrandt EP2
Mobil
Mobilegrease XHP 222
Shell
Alvania EP2
Texaco
Multifak EP2
Molycote
BR2 Plus
Overhaul
T
WARNING Overspeed could result in serious
injury or death
If speed governor is used, check that correct speed
►
governor is assembled. Careless handling may put
it out of order
Do not disassemble security parts, e.g. speed
►
governor or overspeed shut-off. These parts must
be completely replaced when damaged
Always check the free speed of the machine after
►
service. See Section Preparation before using the
die grinder
The entire machine should be checked regularly at
six-months intervals. If it is in heavy duty service or
not running properly it should be taken out of service
more often for inspection.
The strainer at the air inlet should be cleaned fre-
quently to prevent clogging and decreased capacity.
A
Clean the motor parts and apply a thin layer
of air lubrication oil onto the vanes and inner
surface of cylinder and end plates.
Assemble the motor and check that it is run-
ning free. Add two drops of oil through the
air inlet and run the motor at idling speed for
5-10 seconds.
Useful information
C Log in to Atlas Copco www.atlascopco.com
You can find information concerning our products,
accessories, spare parts and published matters on our
website.
Air lubrication
Energol E46
Arox EP46
Chopin 46
Almo oil 525
Tonna R32
Aries 32
7
