Idiomas disponibles
Idiomas disponibles
Anleitung_LB5_4010413:_
health.
The work area must exceed 30 m
■
sufficient ventilation must be ensured during
spraying and drying. Do not spray against
the wind. Always adhere to the regulations
of the local police authority when spraying
combustible or hazardous materials.
Do not process media such as white spirit,
■
butyl alcohol and methylene chloride with
the PVC pressure hose. These media will
destroy the pressure hose.
2.4 Operating pressure vessels
You must keep your pressure vessel in good
■
working order, operate the vessel correctly,
monitor the vessel, carry out necessary
maintenance and repair work immediately
and meet the relevant safety precautions.
The supervisory authority may enforce
■
essential control measures in individual
cases.
A pressure vessel is not allowed to be used
■
if it has faults or deficiencies that can
endanger workers or third parties.
Check the pressure vessel for signs of rust
■
and damage each time before using. Do not
use the compressor with a damaged or rusty
pressure vessel. If you discover any
damage, then please contact the customer
service workshop.
Do not lose this safety information.
3. Layout
1. Transport handle
2. Pressure switch
3. Pressure regulator
4. Quick-lock coupling (regulated compressed
air)
5. Pressure gauge (for reading the preset
pressure)
6. Non-return valve with discharge line
7. Pressure vessel
8. Supporting foot
9. Drain plug for condensed water
10. Axle screw
11. Wheel
28.02.2011
13:52 Uhr
Seite 49
12. Handle
3
and
13. Compressor pump
14. Pressure gauge (for reading the vessel
pressure)
15. Air filter
16. Oil sealing plug
17. ON/OFF switch
18. Oil drainage screw with oil level window
19. Safety valve
20. Quick-lock coupling (unregulated
compressed air)
21. Oil filler opening
22. Washer
23. Spring washer
24. Nut
25. Screw
26. Washer
27. Washer
28. Nut
4. Intended use
The compressor is designed to generate
compressed air for compressed-air driven tools
which can be driven with an air volume of up to
approx. 400 l/min (e.g. a tire inflator, blow-out
pistol and paint spray gun). Compressed air
tools with very high air consumption have only
limited suitability for use with this compressor.
For tools with high air consumption (e.g. orbital
sanders/grinders, rod grinders, hammer
screwdrivers), check whether the compressor's
air output is sufficient to operate the tool in
question. The volume of air supplied by the
compressor must be greater than the volume of
air consumed by the compressed air tool at its
operating pressure.
The equipment may only be used for the tasks it
is designed to handle. Any other use is deemed
to be a case of misuse. The user/operator and
not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
GB/
MT
49
