Assembly; Tools Required - wolfcraft 6137 Manual Del Propietário

Banco para sierra de ingletes

ASSEMBLY

Tools required:

• #2 Phillips
screwdriver
®
• Hammer
• 2 adjustable wrenches
Position wheel bracket
assemblies on legs
1. Place frame assembly (A) on a flat
surface, upside-down, as shown.
See Figure 1.
A
2. Open TOP TWO LEGS ONLY by
disengaging locking pins and rotating
the legs until the locking pins snap
into open position. If depressing the
locking pins is difficult, move the leg
slightly to eliminate pressure on the
pin. See Figure 2.
Press locking
pin to move leg
Figure 1
Figure 2
9
3. Remove two rubber footpads (N)
from the short legs that will receive
the wheels. Slide one bracket and
wheel assembly (C) over end of
each short leg . DO NOT assemble
the screw and nut through the
bracket at this time. See Figure 3.
4. Open remaining two folded legs.
Ensure all four locking pins extend
through holes of brackets.
5. Reinstall two footpads (N) as
illustrated. The shortest corner of
each footpad will point toward the
center of the stand. See Figure 4.
6. Upright stand.
C
Figure 3
N
Figure 4

Capítulos

loading