Add Rubber Feet to Bottom of
Mounting Boards
P (4)
Q (4)
1. With boards removed form stand, in
each board, drill two pilot holes for
screws (Q) to attach rubber feet (P).
Holes should be 5/64" in diameter and
1/2" deep.
2. Attach two rubber feet (P) to each
board. These provide cushioning and
protection when the miter saw is not
mounted to the stand. See Figure 19.
Clamp Mounted Saw to Stand
and Prepare for Use
1. Place saw, mounted to boards, on
center of stand. Position for best
balance. This usually places the
fence of the saw in the center of the
stand. See Figure 21.
2. Position upper clamp brackets in slots
of boards and tighten securely.
3. With telescoping extensions pushed
in, set height of supports even with
table of miter saw.
Figure 19
16
4. Where necessary for proper
alignment, loosen carriage bolts on
support assembly and lightly tap top
of support with a hammer to level with
table of miter saw. Retighten carriage
bolts. See Figure 20.
5. Extend telescoping extensions to
support workpieces and position edge
guide and stop as required.
Tap to level top
of suppport with
saw table
Figure 20
Figure 21
Capítulos
