MOUNTING MITER SAW
Mount Miter Saw to Boards
V (4)
W (4)
X (4)
1. Secure boards to frame of miter saw
stand as explained in "Assemble
Clamps," page 14. Loosen clamps
slightly and spread boards apart
slightly wider than the base of the
miter saw to be mounted.
2. Position miter saw on boards. Saw
base should be approximately 1"
from front edge of boards and 1/2"
from slot in boards. See Figure 17.
NOTE: Position saw and boards so
mounting bolts do not interfere with
frame of miter saw stand.
Typically, for best
CAUTION
balance, the vertical
fence of the miter saw should be
centered, front to back, on the stand.
Be sure to position your saw and
boards for maximum stability.
3. Using a pencil, mark saw base
mounting holes on boards. Remove
saw and boards from stand and drill
mounting holes using a 1/4" bit. Use
bolts (V), washers (W), and hex nuts
(X) to mount saw to boards. See
Figure 18.
15
Figure 17
Figure 18
Capítulos
