Electrical Connections; Wiring Diagram - Dea TEO 700 Instrucciones De Uso

5 ELECTRICAL CONNECTIONS

Execute the wiring following the directions of the diagrams.
WARNING To ensure an appropriate level of electrical safety always keep the 230V power supply cables apart (minimum 4mm
in the open or 1 mm through insulation) from low voltage cables (motors power supply, controls, electric locks, aerial and auxiliary
circuits power supply), and fasten the latter with appropriate clamps near the terminal boards.
WARNING Connect to the power supply 230 V ~± 10% 50 Hz through a multi pole switch or a different device that can ensure
multi pole disconnection from the power supply, with a contact opening of 3 mm.
WARNING To connect the encoder to the control panel, use only a dedicated cable 3x0,22mm
BATTERY
AC/24V

Wiring Diagram

PHOTO 1
TX RX
ROSSO NERO
RED BLACK
ROUGE NOIRE
ROJO NEGRO
VERMELHO PRETO
CZERWONY CZARNY
MOTOR
.
2
OPEN
FLASH
11