Idiomas disponibles
Idiomas disponibles
Safety and operating instructions
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
To prevent an accidental start: switch off the air
♦
supply and disconnect the machine from the power
source. Bleed the machine by pressing the start
and stop device.
Before inserting a tool, lubricate the tool shank
♦
with grease.
Close the tool retainer and check the lock function
♦
by tugging the inserted tool sharply outwards.
1. Place the cap over the body of the insertion tool.
2. Place the buffer (A) over the stem of the insertion
tool.
3. Insert the insertion tool into the cylinder and
screw the cap onto the cylinder until it is locked.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
16
A
TEX 03PS, 05P, 05P H/R, 05P R
Start and stop
Start the machine by squeezing the trigger while
firmly holding the handle.
TEX 03PS
Stop the machine by releasing the trigger. The trigger
returns automatically to the stop position.
TEX 03PS
Operating
Starting a cut
♦
Stand in a stable position with your feet well away
from the inserted tool.
♦
Press the machine against the working surface
before you start.
♦
Start collaring at such a distance from the edge
that the machine is capable of breaking the
material without levering.
♦
Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool does
not get stuck.
© 2015 Construction Tools PC AB | No. 9800 0975 90c | 2015-01-13
TEX 05P
TEX 05P
A
Original instructions
