Barrier
Install_NQ70M9770D_AA_DE68-04502A-00_EN+MES+CFR.indb 13
3.
Push oven completely into the cabinet
and center the oven into the cabinet
cutout.
4.
Remove the tape from front trims.
•
Securely fasten the oven to the
cabinet using the screws provided.
•
Insert the screws through hole in
trim aligning with hole in lower
oven frame. Do not overtighten
screws.
WARNING
When inserting the oven, use caution not to
deform or damage the barrier underneath.
Self-diagnosis
Temp sensor & Heater check
1.
After connecting the power, check if the display works properly.
2.
Remove all accessories (Gliding Rack, Flat-Rack, Smart Divider...etc.) from
inside of the oven cavity.
You cannot proceed with self-diagnosis if the oven cavity is hot or the door is
3.
open.
•
In this case, "Hot or door" message appears on the display.
4.
To start self-diagnosis, press both Hidden Keys simultaneously for 5 seconds.
•
Refer to the table below for the hidden keys for each model.
•
Self-diagnosis takes approximately 4 ~ 5 minutes.
Model
Control panel
Hidden Key
MICROWAVE + LOWER OVEN
NQ70M9770**
English 13
2017-07-31
11:37:25