Idiomas disponibles
Idiomas disponibles
TABLETOP POWER STRIP ASSEMBLY
1. Choose desired location for power strip. Place two
supplied mounting clips roughly 32" apart (clip side
up). Using an electric drill, fasten to tabletop with
two supplied wood screws. (See Figure 30)
Figure 30
Mounting Clip
2. Secure power strip by snapping into the mounting
clips. (See Figure 31)
MONITOR ARM ASSEMBLY
1. Align monitor arm mounting bracket with uprights
at desired height.
2. Secure to uprights with two M6 x 35 mm or M6 x 50 mm
Allen head bolts, two small flat washers and two hex
nuts using an Allen wrench and 10 mm wrench.
(See Figure 32)
Figure 32
Small Flat
Washer
Hex Nut
Allen Head
Bolt
PAGE 9 OF 42
OPTIONAL ACCESSORIES CONTINUED
Figure 31
ATTACHING MONITOR
NOTE: Ensure monitor has a VESA hole pattern of
100 x 100 mm or 75 x 75 mm. (See Figure 33)
NOTE: If monitor is attached to a fixed base,
remove monitor from base.
CAUTION! Be careful not to scratch screen
during installation.
Figure 33
75 x 75 mm or
100 x 100 mm
1.
Easy-adjust monitor mount includes a built-in
counterweight system for free-range motion. Arm in
mount may need to be adjusted to allow monitor to
stop at desired position. Attach monitor to plate.
(See Figure 34)
Figure 34
Allen
Wrench
Use appropriate bolts for monitor.
2. To adjust the counterweight, use 5 x 5 Allen wrench
on screw above middle joint. Turn toward "–" if
monitor raises up. Turn toward "+" if monitor lowers.
Adjust until mount can be stopped at desired
position. (See Figure 35)
Figure 35
±180º -85º ~15º
Adjust swivel
with Allen
Wrench
Large Flat
Washer
Adjust Tilt with
Allen Wrench
±90º
±180º
0323 IH-10268
