Idiomas disponibles
Idiomas disponibles
3. Place shelf on brackets. Install to brackets with
four 5/8" bolts and flange nuts. (See Figure 20)
5/8" Bolt
Flange Nut
PEGBOARD AND LOUVERED PANEL
ASSEMBLY
1.
Position panel mounting bars at desired height on
the uprights. There should be eight open holes on
the upright between the top and bottom bar to
allow for panel mounting. Secure bars to upright
with four 1⁄" bolts. (See Figure 21)
NOTE: The holes on the face of the mounting
bars should be facing the inside direction.
1½" Bolt
Panel Mounting Bar
2. Attach panel brackets to pegboard panel or
louvered panel. Align holes on bracket with the four
holes on the ends of the panels. Attach four 5/8"
bolts and flange nuts on the center holes only.
(See Figure 22)
Figure 22
5/8"
Bolt
PAGE 7 OF 42
OPTIONAL ACCESSORIES CONTINUED
Figure 20
Shelf
Figure 21
Flange Nut
Panel Bracket
Panel
3. Install panels (pegboard and/or louvered) to the
mounting bars. Align holes on the top and bottom of
the panel with the holes in the bar. Secure using four
1⁄" bolts and flange nuts. (See Figure 23)
4. Repeat for additional panels. The 48" workstation
holds up to two panels, 60" and 72" workstations
hold up to three panels, and the 96" workstation
holds up to four panels.
5. Assembly is complete. (See Figure 24)
Figure 23
Flange Nut
1½"
Bolt
Figure 24
Completed Assembly
0323 IH-10268
