Idiomas disponibles
Idiomas disponibles
14. Place stringer cover over holes on stringer. Tighten
Allen head bolts on bottom of stringer to secure.
(See Figures 14a-14b)
Figure 14a
15. Connect ethernet style cords to M1-M4 ports on
control box and lifting columns. (See Figures 15-16)
Figure 15
Lifting Column
16. Connect handset to part labeled "HS" and power
cord to power port labeled "AC" on control box.
(See Figure 16)
NOTE: Cable ties may be used on underside
of tabletop to hide cords.
Figure 16
Power Port
PAGE 5 OF 42
ASSEMBLY CONTINUED
Figure 14b
Control Box
Ports for Lifting Columns
Handset Port
UPRIGHT ASSEMBLY
1. Carefully set table upright and recheck all nuts,
bolts and screws for tightness.
2. Position upright on back corner of tabletop. The
mounting plate should be positioned directly over
the previously drilled holes. Fasten four 2⁄" bolts
and washers through uprights, tabletop and support
plates using 10 mm wrench. Secure with flange nuts
on underside of table. (See Figure 17)
3. Repeat steps 1-2 for remaining upright. (See Figure 17)
Figure 17
Upright
2⁄" Bolt
Washer
Flange Nut
Leg
Mounting
Plate
0323 IH-10268
