Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
H-10385, H-10386
H-10387
WIRE BASKET CARTS
TOOL NEEDED
Rubber Mallet
Post x 4
Basket x 1
Figure 1
1.
Start with the lowest shelf. Snap the interlocking
pieces of a shelf support (wide end down) around
the post at the lowest groove where shelf is to be
located. Slide the support up or down until it snaps
onto the groove. Add a shelf support to the same
place on the remaining posts. (See Figure 2)
NOTE: NSF requires food service applications to
keep the lowest shelf at least 6" above the floor.
Figure 2
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Shelf x 2
CASTER INSTALLATION
TO INSTALL CASTERS
1.
Make sure post is positioned as shown. (See Figure 1)
2. Engage the wheel brakes to keep casters from rolling during assembly. Use
a rubber mallet to tap caster stems into posts. (See Figure 1)
ASSEMBLY
Shelf
Support
Pour le français, consulter les pages 5-6.
Handle x 1
2. Slide post through underside of shelf until shelf slides
firmly over supports. (See Figure 3)
NOTE: Shelf should be placed so 1" lip faces
upward.
Figure 3
Para Español, vea páginas 3-4.
Shelf Support
Caster x 4
x 14 Sets
1122 IH-10385
Tabla de contenido
Manuales relacionados para Uline H-10385
Resumen de contenidos para Uline H-10385
-
Página 3: Carritos De Canasta De Alambre
H-10385, H-10386 800-295-5510 H-10387 uline.mx CARRITOS DE CANASTA DE ALAMBRE HERRAMIENTA NECESARIA Mazo de Caucho PARTES 4 Postes 1 Canasta 2 Repisas 1 Asa 14 Sets de Soportes 4 Ruedas para Repisa INSTALACIÓN DE LAS RUEDAS PARA INSTALAR LAS RUEDAS 1. -
Página 4: Continuación Del Ensamble
Coloque los soportes para repisa restantes en la parte superior de los postes. Deslice la canasta sobre la parte superior de los soportes y asegúrela. (Vea Diagrama 7) Diagrama 5 Diagrama 7 800-295-5510 uline.mx PAGE 4 OF 6 1122 IH-10385...