Idiomas disponibles
Idiomas disponibles
NOTE: Support beams may need to expand for
the holes to align. To expand, loosen eight
pre-installed Allen head bolts. (See Figure 5a)
Adjust length of support beams. (See Figure 5b)
Evenly expand both sides, ensuring there is
metal material under holes for bolts to attach.
Figure 5a
NOTE: Re-tighten
pre-installed
Allen head bolts
and install four
additional
"B" Allen head
bolts into locations
shown in Figure 5c
for each support
beam.
6. Using 12 "E" Phillips head screws and drill with Phillips
head drill bit, fasten frame assembly to tabletop.
(See Figure 6)
NOTE: Use shaded circles as guide for
attachment points. Holes are not pre-drilled.
Figure 6
PAGE 3 OF 42
ASSEMBLY CONTINUED
Figure 5b
Figure 5c
B
E
7.
Using shaded circles as a guide, drill eight holes fully
through tabletop with 1/4" drill bit. (See Figure 7)
NOTE: These holes are drilled to allow mounting
of uprights on page 5.
Figure 7
8. Center control box between support beams.
Secure control box to underside of tabletop
using two "E" Phillips head screws and drill with
Phillips head drill bit. (See Figure 8)
Figure 8
E
0323 IH-10268
