Component & Control Location; Features; Before Operation Checks; Is Your Engine Ready To Go - Honda GX630 Manual Del Propietário

COMPONENT & CONTROL LOCATION
SPARK PLUG
OIL FILTER
OIL DRAIN BOLT
OIL LEVEL DIPSTICK
OIL FILLER CAP
SPARK PLUG
OIL DRAIN BOLT
ELECTRIC STARTER

FEATURES

Oil Alert® System (applicable types)
''Oil Alert is a registered trademark in the United States''
The Oil Alert system is designed to prevent engine damage caused
by an insufficient amount of oil in the crankcase. Before the oil
level in the crankcase can fall below a safe limit, the Oil Alert
system will automatically stop the engine (the engine switch will
remain in the ON position).
If the engine stops and will not restart, check the engine oil level
(see page 6) before troubleshooting in other areas.
Fuel System
This engine uses LPG or NATURAL GAS and requires a fuel
regulator and related parts that are not included with the engine.
Proper installation and maintenance of these parts should be
performed by your servicing dealer.
AIR CLEANER
PROTECTOR FAN
COVER
MUFFLER (B type OPTIONAL EQUIPMENT)
MUFFLER (A type
OPTIONAL EQUIPMENT)

BEFORE OPERATION CHECKS

IS YOUR ENGINE READY TO GO?

For your safety, to ensure compliance with environmental
regulations, and to maximize the service life of your equipment, it is
very important to take a few moments before you operate the
engine to check its condition. Be sure to take care of any problem
you find, or have your servicing dealer correct it, before you
operate the engine.
Improperly maintaining this engine, or failure to
correct a problem before operation, can cause a
malfunction in which you can be seriously hurt or
killed.
Always perform a pre-operation inspection before
each operation, and correct any problem.
Before beginning your pre-operation checks, be sure the engine is
level and the engine switch is in the OFF position.
Always check the following items before you start the engine:
Check the General Condition of the Engine
1. Look around and underneath the engine for signs of oil leaks.
2. Remove any excessive dirt or debris, especially around the
muffler and fan cover.
3. Look for signs of damage.
4. Check that all shields and covers are in place, and all nuts,
bolts, and screws are tightened.
Check the Engine
1. Check the engine oil level (see page 6). Running the engine with
a low oil level can cause engine damage.
The Oil Alert system (applicable types) will automatically stop
the engine before the oil level falls below safe limits. However,
to avoid the inconvenience of an unexpected shutdown, always
check the engine oil level before startup.
2. Check the air filter element (see page 7). A dirty air filter
element will restrict air flow to the carburetor, reducing engine
performance.
3. Check the equipment powered by this engine.
Review the instructions provided with the equipment powered
by this engine for any precautions and procedures that should
be followed before engine startup.
ENGLISH
3