Installing The Handle; Installing The Guard - Makita DUR361U Manual De Instrucciones

NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.

Installing the handle

1
3
012456
Insert the shaft of the handle into the grip as shown.
Align the screw hole in the grip with the one in the shaft.
Tighten the screw securely.
Fit the barrier and grip onto the shaft pipe with four screws.
Make sure that the spacer on the shaft pipe is located
between the grip/barrier assembly and the hanger.
1 1
014752
Place handle between handle clamp and handle holder.
Adjust the handle to an angle that provides a
comfortable working position and then secure by firmly
hand-tightening knob.

Installing the guard

WARNING:
Never use the tool without the guard illustrated
•
in place. Failure to do so can cause serious
personal injury.
1. Grip
2. Handle
3. Screw
2
1. Screw
2. Handle clamp
2
For cutter blade
014755
1
3
4
014760
Install the protrusion of the protector clamp to the gear
case until aligning the position with the label on the pipe.
Fix the protector to the protector clamp with the two
bolts and then tighten both bolts by the hex wrench
evenly.
For nylon cutting head (optional accessory)
1
014833
Remove the hex bolts with hex wrench. Then remove
the protector clamp and protector.
2
3
014834
Install the protector attachment and protector holder
attachment to the gear case.
11
1. Label
2. Hex bolts
2
3. Protector clamp
4. Gear case
5
5. Protector
1. Protector
2. Hex bolt
2
1. Gear case
2. Protector holder
1
attachment
3. Protector
attachment