Installing The Guard - Makita BBC300L Manual De Instrucciones

Installing the guard

1
2
010768
WARNING:
Only the cutting tool/guard combinations as
•
indicated below must be used. Failure to do so can
cause serious injury. Never use the equipment
without the guard.
CAUTION:
Take care not to injure yourself on the cutter for
•
cutting the nylon cord on the inside of the guard
extension.
Be sure to push in the guard extension until it is
•
fully inserted.
1
010778
1
2
010777
Fix the guard to the clamp with two bolts as shown.
Tighten the right and left bolts evenly.
Mount the guard extension by sliding it into place from
the flank of the guard as shown.
NOTE:
Remove tape adhered to cutter, which cuts nylon
•
cord, on guard extension at the first use.
1. Nylon cutting
head
2. Guard
3. Guard extension
3
1. Two bolts
2. Protector cover
3. Guard
2
3
1. Guard
2. Guard
extension
010849
To remove the guard extension, apply a flat-blade
screwdriver into the notch on the guard, push it in and
meanwhile slide the guard extension.
Installing of nylon cutting head
CAUTION:
Always mount not only guard but also guard
•
extension when using nylon cutting head.
Be sure to use genuine Makita nylon cutting head.
•
If the nylon cutting head hits against a stone during
•
operation, stop the motor and check the nylon
cutting head immediately.
Turn the machine upside down so that you can replace
the nylon cutting head easily.
3
1
2
010769
Insert the hex wrench through the hole on the protector
cover and the gear case and rotate the receive washer
until it is locked with the hex wrench. Mount the nylon
cutting head onto the threaded spindle directly and
tighten it by turning it counterclockwise. Remove the hex
wrench.
To dismount the nylon cutting head, turn the nylon
cutting head clockwise during holding the receive
washer with hex wrench.
OPERATION
Correct handling of machine
Correct posture
WARNING:
Always position the equipment on your right-hand
•
side so that the shaft of the barrier is always ahead
of you. The correct posture reduces the risk of
injury caused by kickback.
9
1. Threaded
spindle
2. Hex wrench
3. Receive washer