Water Connection; Starting Procedure - ESAB Warrior Feed 304 Manual De Instrucciones

GB
5.2

Water connection

When connecting a water-cooled welding gun, the power source's main power
supply switch must be in the OFF position and the cooling unit switch must be in
position 0.
A water connection kit can be orderred as accessory, see on page 50.
5.3

Starting procedure

When the wire feed starts, the power source generates welding voltage.
If there is no welding current flow within three seconds, the power source switches
the welding voltage off. The wire feed continues until the welding gun's switch is
switched off.
bm55d1e
- 39 -
© ESAB AB 2013