Replacing The Batteries; Maintenance; Storage - Parkside PHDP 180 C2 Traduccion Del Manual De Instrucciones Originales

Clean the device with a soft brush or a
4.
slightly damp cloth.
5. Occasionally clean the filter insert un-
der running water.
Cleaning the 3-in-1 nozzle
In rare cases, the 3-in-1 nozzle may be-
come clogged by foreign bodies.
1. Remove the 3-in-1 nozzle (23).
Adjust the 3-in-1 nozzle so that the
2.
nozzle to be cleaned and the connec-
tion are in a straight line.
Remove the foreign body from the front
3.
using the nozzle cleaning needle (6).
4. Rinse the 3-in-1 nozzle with water from
the front to remove the foreign body.
Cleaning the filter insert in the wa-
ter connection
1. Remove the quick connector for the
garden hose (29) from the water con-
nection (28).
Remove the filter insert (30) from the
2.
water connection.
Clean the filter insert under running wa-
3.
ter.
4. Fit the filter insert and quick connector
in the opposite order.

Replacing the batteries

Replace the batteries if the LC display (15)
is not displaying anything.
Power tools required
• Phillips screwdriver (not included)
Replacing the batteries
1. Remove the screw from the battery
compartment cover (16).
Remove the cover of the battery com-
2.
partment.
Replace the batteries (35) in the bat-
3.
tery compartment with new batteries.
Pay attention to the correct polarity
when inserting the batteries in the bat-
tery compartment.
Press the switch lever (17) on the trig-
4.
ger gun (1).
The LC display shows the selected pres-
sure. If the LC display is not displaying
anything, check whether the batteries
are inserted correctly.
Insert the cover of the battery compart-
5.
ment.
6. Fasten the cover of the battery com-
partment using the screw.

Maintenance

The device is maintenance free.

Storage

Information on storage
Always store the device and accessories:
• clean
dry
•
protected against dust
•
protected against frost
•
• out of the reach of children
Preparing the device for storage
NOTICE! The pressure washer and ac-
cessories will be destroyed by frost if they
are not completely emptied of water.
1. Completely empty the water from the
device.
• Disconnect the device from the wa-
ter supply.
• Turn on the pressure washer with the
On/Off switch (32) for a maximum
of 1 minute.
• Press the switch lever (17) on the
trigger gun (1) until there is no more
water coming out of the trigger gun
(1) or the attachments.
• Turn off the device.
Completely empty the water from the
2.
accessories.
Store all attachments upright in the
3.
holders with the connection facing
downwards.
GB MT
39