EVVO CLIMA P9 Manual De Instrucciones página 65

Fan speed
In cooling mode, press the corresponding icon to select a high or low wind-speed
setting.
This option is not available under the dehumidification mode.
NOTE:
Under certain conditions (defrost), it may not operate at the selected speed.
Timer
Press this icon to set the timer. When the timer symbol blinks, use the increase and
decrease icons to select the desired operating time.
The timer can be set from 1 to 24 hours, and the digits increase and decrease by 1 hour.
Drainage instructions
When the air conditioner stops operating because the water tank is full, turn it off and
unplug it from the power supply. The full-tank indicator (FULL) will start blinking and
the appliance will not operate until the water inside the tank is drained.
Manual drainage. Fig. 10
Place a container below the water outlet behind the body.
Unscrew the drain cap and unplug the water plug. The water will automatically flow
into a container.
NOTE:
- Move the device carefully, so as not to spill the water in the water tank at the
bottom of the body.
- Keep the drain cap and the water plug properly.
- During drainage, the body can be tilted slightly backwards.
- If the water container cannot hold all the water, before the water container is full,
stuff the water outlet with the water plug as soon as possible to prevent water
from flowing to the floor or the carpet.
- When the water is discharged, re-tighten the water plug and tighten the drain
cap.
- Restart the appliance after the plug and cap are installed, otherwise condensed
water of the appliance will flow to the floor or the carpet.
Continuous drainage. Fig. 11
Unscrew the drain cap and unplug the water plug.
Set the drainage pipe into the water outlet.
Connect the drainage hose to a bucket or big container.
ENGLISH
65
CLIMA P9 3 IN 1