Idiomas disponibles
Idiomas disponibles
CARBURETOR ADJUSTMENT
WARNING! The chain will be moving during
most of this procedure. Wear your
protective equipment and observe all safety
precautions. The chain must not move at
idle speed.
Indications for idle speed adjustment
The carburetor has been carefully set at the
factory. Adjustments may be necessary if you
notice any of the following conditions:
• The chain moves at idle. See IDLE SPEED-T
ADJUSTMENT procedure.
• The saw will not idle. See IDLE SPEED-T
ADJUSTMENT procedure.
Idle speed-T adjustment
Allow the engine to idle. If the chain moves, the
idle is too fast. If the engine stalls, the idle is too
slow.
Adjust the speed until the engine runs without
chain movement (idle too fast) or stalling (idle too
slow).
All manuals and user guides at all-guides.com
The idle speed screw is located in the area above
the primer (air purge) bulb and is labeled "T".
Turn the idle speed screw (T) clockwise to
increase the engine speed.
Turn the idle speed screw (T) counterclockwise to
decrease the engine speed.
STORAGE
• Before storing, drain all fuel from the unit. Start
• Clean the unit before storing. Pay particular
• Ensure the machine is cleaned and that a
• The guide bar and chain should be covered with
15
WARNING! Stop the engine and allow it to
cool. Secure the unit before storing or
transporting it in a vehicle. Store the unit
and fuel in an area where fuel vapors cannot
reach sparks or open flames from water
heaters, electric motors, switches, furnaces,
etc.
WARNING ! Store the unit with all guards in
place. Position so that any sharp object
cannot accidentally cause injury to
passersby. Store the unit out of reach of
children.
the engine and allow it to run until it runs
completely out of fuel.
attention to the air intake area, keeping it free of
debris. Use a mild detergent and sponge to
clean the plastic surfaces.
complete service is carried out before long-term
storage.
a scabbard when the machine is being
transported or in storage in order to prevent
accidental contact with the sharp chain. Even a
non-moving chain can cause serious cuts to
yourself or others that make contact with an
exposed chain.
CAUTION: It is important to prevent gum
deposits from forming in essential fuel system
parts such as the carburetor, fuel filter, fuel
hose, or fuel tank during storage. Alcohol
blended fuels (called gasohol) or using ethanol
or methanol can attract moisture which leads to
fuel mixture separation and formation of acids
during storage. Acidic gas can damage the
engine.
