Lenco L-174 Manual Del Usuario página 6

Idiomas disponibles
  • ES

Idiomas disponibles

6)
If you want to pause the playing, switch the knob on the left side to
"off", and switch it to 33 or 45 to continue the playing.
7)
After finish the playing, please switch off the power to save energy.
Record to PC
Connect USB to PC for editing the music with your favorite digital editing software.
With this unit, we offer you a disc with PC music editing program, please refer to
the instructions attached to this manual for the operation.
MAINTENANCE
To replace the stylus (FIG.A)
• Secure the tone arm in place using the
tone arm lock.
• Pull the orange stylus unit forward in the
direction of arrow (A) and remove it.
• Put in the new stylus following the
reverse procedure.
To disassemble the cartridge
(FIG.B)
• Secure the tone arm in place using the
tone arm lock.
• Remove the stylus (see section above).
• Release the screws, nuts and washer
and then the headshell and cartridge
can be disassembled.
• Disconnect the four link wires at the
level of the pick-up head.
To install a new cartridge
• Connect the four colored wires as
shown in figure B.
• Push the cartridge up into the headshell.
• Reinstall the stylus.
Important recommendations
We advise you to clean your records using an impregnated rag with an anti-static
fluid in order to enjoy your records maximally and also to make them last longer.
We would also like to point out that for the same reasons your stylus should be
replaced periodically (approximately every 250 hours)
Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing
from back to front of the cartridge)
BACK VIEW OF HEADSHELL WIRING
WHITE
BLUE
6
FIG A
FIG B
RED
GREEN
loading