Idiomas disponibles
Idiomas disponibles
8.
Signal Connectors
Plug in the RCA cable, and connect the cable to an audio amplifier.
9.
Pre-Amp ON/OFF selector
* ON: Connect the RCA cable to the LINE-IN terminal of the amplifier.
* OFF: Connect the RCA cable to the PHONO-IN terminal of the amplifier.
Warning: If the selector is in the ON position, never connect the RCA cable to
the PHONO-IN terminal of the amplifier.
10. USB port
Connecting to PC for recording music from your vinyl to a PC.
-
With Full-Speed Transceivers
-
Fully Compliant With USB 1.1 Specification
11. Auto Stop Switch
When the record heads towards the end, it will automatically stop. The records
sometimes have various ending points. In case the record auto-stops before it
reaches the end of the vinyl record, please switch off the auto-stop function.
12. Power supply jack:
To plug-in DC12V/0.5A switching adaptor for power supply.
13. Power Switch:
During the PAUSE mode (33/off/45 switch is on "OFF" position), the motor is
still activated; to save energy, please switch off the player after using it.
INITIAL STARTING-UP
Mount and adjust
1)
Place the aluminum turntable platter. See below, reach into the hole and pull
the rubber drive belt off of the inner ring, and install it over the motor spindle.
Be careful not to twist the rubber drive belt during this step. Check to make
sure the platter rotates uniformly.
2)
Insert the counterweight on the end of the tone arm, this locks it into place.
3)
Adjusting the stylus pressure
i.
Turn the anti-skating knob counter-clockwise to "0".
ii.
Pull down the protective cover of the stylus.
iii.
Place the lever for the tone arm lift in the front position.
iv.
Open the tone arm lock. Seize the handle of the tone arm and lead it to just
before the turntable platter so that it can be moved upwards and downwards.
(Be careful not to hit the stylus against anything.)
4) Turn the counterweight until the tone arm remains in a horizontal position and
4
