LUCCI FIJIAN II Serie Manual De Instrucciones página 6

Fijian II Installation Instructions
Install the down rod
1. Loosen the hanger ball. (see Fig.4)
2. Feed the down rod through the canopy.
3. Insert the motor wires through the down rod, and then
secure the hanger ball back to the down rod.
4. Insert the down rod to the coupling, line up the
coupling holes with the down rod holes and insert the
bolt. Then insert the pin to end of the bolt.
5. Finally secure the down rod and coupling by tightening
two set screws on the coupling.
Hanging the fan
Lift the fan assembly onto the mounting bracket. Ensure the registration slot (A) of the hanger ball is
positioned on the stopper (B) of the mounting bracket (C) to prevent the fan from rotating when in
operation. (Fig.4)
Blade attachment
Before Installing the blades, remove the motor screws.
1.
Assemble the blades and blade holders using the screw set. (Fig. 6)
2.
Secure the blade on the motor by tightening 2 screws with washers. Ensure all screws are tightened
3.
envently to reduce the chance of warping or unbalancing. (Take care not to over tighten as this can
damage blades). Repeat the process on remaining blades. (Fig.7)
6 | P a g e
HANGING THE FAN
BLADE INSTALLATION
Fig. 4
Fig. 5