Idiomas disponibles
Idiomas disponibles
Before use
Charging the battery pack
(see fig. A)
CAUTION!
►
Always unplug the charger before you remove
the battery pack
charger.
NOTE
►
The recommended ambient temperature
range for using tools and batteries is between
–5°C and 50°C.
►
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦
Connect the battery pack
battery charger
♦
Insert the mains plug into the mains socket.
The control LED
♦
The green control LED
charging process is complete and the battery
pack
is ready for use.
ATTENTION!
♦
If the red control LED
that the battery pack
cannot be charged.
♦
If the red and green control LEDs
flash, this means that the battery pack
defective.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
■
8
│
GB │ IE
from or connect it to the
to the high-speed
(see fig. A).
lights up red.
indicates that the
flashes, this means
has overheated and
both
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦
Allow the battery pack
the appliance.
Removing the battery pack
♦
Press the release button
battery pack
Checking the battery charge level
♦
Press the battery charge level button
the status of the battery (see also figure A on
the fold-out page).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Operation
NOTE
►
The appliance vibrates during operation.
Place it on a solid surface during operation.
There are four feet
appliance for this purpose.
ATTENTION!
►
This appliance is not designed for contin-
uous operation. The appliance may be used
for a maximum of 10 minutes continuous
operation. If the appliance overheats, remove
the battery pack
cool down completely and then try using it
again.
♦
Remove the required accessories from the
is
storage compartment
to click into place in
and remove the
.
as follows:
on the bottom of the
. Allow the appliance to
.
PKA 20-Li B2
to check
