Idiomas disponibles
Idiomas disponibles
FIG. 9
RECOMMENDED CUTTING POSITIONS
YES
NO
YES
NO
YES
NO
MAINTENANCE
YES
NO
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Lubrication
Self-lubricating bearings are used in the tool and periodic relubrication
is not required. In the unlikely event that service is ever needed, take
your tool to an authorized service location.
Cleaning
YES
NO
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
YES
NO
CHARGER CLEANING INSTRUCTIONS
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
Accessories
D
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
this product.
15
WARNING: To reduce the risk of serious personal injury,
WARNING: Blow dirt and dust out of all air vents with clean, dry air
WARNING: Never use solvents or other harsh chemicals for
WARNING: Shock hazard. Disconnect the charger from the AC
WARNING: Since accessories, other than those offered by
WALT, have not been tested with this product, use of such
WALT recommended accessories should be used with
E
