Idiomas disponibles
Idiomas disponibles
To ignite burners using match lighting:
Open the hood.
Turn all control knobs on the control panel off ( O ).
Make sure the regulator is tightly connected to the LP
gas cylinder and a leak test has been performed.
Open the cylinder valve completely.
Using the match holder included with this grill, place a
match between the circular wire.
Light the match and place into lighting hole on the side
of the firebox.
Push in the far right control knob and turn to ON
When burner is lit, turn the control knob to the desired
setting.
If burner fails to light, extinguish the match then turn
the control knob off and wait five (5) minutes then
repeat the step.
NOTE: Place burner on high and observe flame height
which should be approximately 1 inch. If flame is too
high or too low, burner adjustment is required. See the
Adjustment section later in this manual.
To light other burners: push in and turn on the control
knob next to the lit burner to light.
Fig. 28
OPERATION
.
MATCH
HOLDER
LIGHTING
HOLE
21
RESETTING THE GAS REGULATOR SAFETY
DEVICE
Since 1995, all regulators include a safety feature that re-
stricts gas flow in the event of a gas leak. If you turn on the
control knob before turning on the cylinder valve, you can
activate this feature. Even with all the burners turned on high,
the grill won't get hotter than 250°F to 300°F. It will then be
necessary to reset the gas regulator safety device.
To reset:
Open the hood and turn all control knobs on the
control panel off ( O ).
Close cylinder valve completely and disconnect the
regulator from the LP gas cylinder.
Wait 30 seconds the reconnect the regulator.
Open cylinder valve and follow igniting instructions.
USING THE GRILL AND ACCESSORIES
See Figure 29.
WARNING:
Never use an accessory if the porcelain coating is
damaged or chipped. Use with a damaged coating
could result in serious personal injury if ingested.
NOTE: Only use the insert removal tool on tabbed inserts.
To use the insert removal tool:
Slide the hooks on the end of the insert tool under the
tab on the insert.
INSERT
TOOL
Fig. 29
TAB
RELEASE
BUTTON
