Intended Use - DeWalt D28111 Manual De Instrucciones

• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
WARNING: Always use eye protection. All users and
bystanders must wear eye protection that conforms to ANSI Z87.1.
WARNING: When not in use, place grinder on a stable
surface where it will not move inadvertantly, roll or cause a
tripping or falling hazard. Serious personal injury may result.
CAUTION: To reduce the risk of personal injury, use extra care
when working into a corner or edge because a sudden, sharp
movement of the tool may be experienced when the wheel or other
accessory contacts a secondary surface or a surface edge.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V .......... volts
Hz ........ hertz
min ...... minutes
... direct current
........ Class I Construction n o ........ no load speed
............ ............ (grounded)
........ Class II Construction
............ (double insulated)
A .......... amperes
W......... watts
....... alternating current
....... alternating or direct current
........ earthing terminal
......... safety alert symbol
BPM .... beats per minute
.../min . per minute
IPM ...... impacts per minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. All D WALT tools are factory tested; if this tool does not
E
operate, check the power supply.
DESCRIPTION (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. On/Off switch C. Guard
B. Spindle Lock D. Side Handle

INTENDED USE

Your angle grinder has been designed for professional grinding and
cutting applications.
DO NOT use under wet conditions or in presence of flammable
liquids or gases.
DO NOT use grinding wheels other than center depressed wheels
and flap-disk.
This heavy-duty angle grinder is a professional power tool. DO NOT
let children come into contact with the tool. Supervision is required
when inexperienced operators use this tool.
22
RPM .... revolutions per minute
sfpm .... surface feet per minute