DeWalt D28111 Manual De Instrucciones página 26

NOTE: Please refer to the Grinding and Cutting Accessory Chart
at the end of this section to show other accessories that can be used
with these grinders.
D28111
1. Align the lugs (F) on the guard with the slots on the gear case (G).
This will align the lugs on the guard with the slots on the gear case
cover.
2. Push the guard down until the guard lugs engage and rotate freely
in the groove on the gear case hub.
3. Rotate the guard (C) into the desired working position. The guard
body should be positioned between the spindle and the operator
to provide maximum operator protection.
4. Securely tighten the screw (H).
5. To remove the guard, slacken the screw.
FIG. 2A
H
G
D28112
1. Open the guard latch (E), and align the lugs (F) on the guard with
the slots on the gear case (G). This will align the lugs on the guard
with the slots on the gear case cover.
2. Push the guard down until the guard lugs engage and rotate freely
in the groove on the gear case hub.
3. With the guard latch open, rotate the guard (C) into the desired
working position. The guard body should be positioned between
the spindle and the operator to provide maximum operator
protection.
4. Close the guard latch to secure the guard on the gear case. You
should not be able to rotate the guard by hand when the latch
is closed. Do not operate the grinder with a loose guard or the
clamp lever in open position.
5. To remove the guard, open the guard latch, rotate the guard so
that the arrows are aligned and pull up on the guard.
C
F
G
24
FIG. 2B
C
F
E
G
O
G