Parkside PBSD 600 A1 Traduccion Del Manual De Instrucciones Originale página 32

g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions, tak-
ing into account the working conditions and
the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation.
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow
for safe handling and control of the tool in unex-
pected situations.
5. Service
a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
Appliance-specific safety instructions
for grinders
■
Hold the appliance by the insulated handles
as the abrasive belt
with its own power cable. Damage to a live
wire may make exposed metal parts of the
power tool live and could give the operator an
electric shock.
WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health.
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity.
■ Wear safety goggles and a protective dust
mask!
PBSD 600 A1
can come into contact
Operation
Tensioning/replacing the abrasive
belt
WARNING! RISK OF INJURY
■ Always remove the power plug from the wall
socket before carrying out any work on the
belt grinder.
1. Loosen the clamping device for the abrasive
belt by swivelling the clamping lever
the way out. The abrasive belt
removed.
2. Now fit a new abrasive belt
belt to work on a different material or to use a
different grain size.
IMPORTANT: The direction of the arrows on
the inside of the abrasive belt
appliance housing must match.
3. Push the clamping lever
position.
Manually adjusting the abrasive belt
If the belt tracking is not centred when you switch
on the appliance, you may need to manually ad-
just it.
♦ To do this, turn the adjusting screw
front roller until the abrasive belt
centred.
IMPORTANT: It is important to ensure that
the abrasive belt
housing. Check the belt tracking regularly and
adjust it with the adjusting screw if required
Adjusting the additional handle
You can position the additional handle
different positions.
♦ To reposition the additional handle
screw .
♦ Move the additional handle
position.
♦ Retighten the screw
all
can now be
or swap the
and on the
back into its initial
:
on the
is running
does not rub against the
in several
undo the
to the required
.
GB │ MT │
29
.
■