Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Advice on use / Cleaning / Service centre / Warranty
Advice on use
Wait until the device has come to a standstill
before you put it down.
Sanding surfaces
Switch the air sander on and bring the whole
of its sanding area into contact with the surface
to be abraded. Move it using even pressure to
and fro over the workpiece (see Fig. D).
note: The sanding output and appearance are
largely dependent on the choice of sanding
sheet and the pressure applied. A sanding sheet
must be free of defects to produce a good
sanding output.
Ensure that you use an even pressure. Excessive
pressure does not produce a higher sanding out-
put, it just increases the wear on the sanding sheet.
A sanding sheet previously used on metal must
not be used on other materials.
replacing the backing plate
rISK OF InJUrY! Always
disconnect the device from the compressed air
source before you replace the backing plate
Push the open-ended spanner
backing plate
and collar
6
Release the backing plate
plate anticlockwise and holding the open-ended
spanner
still against this movement.
11
Screw on a new backing plate
until tight while holding the open-ended span-
ner
still against this movement.
11
34 GB/MT
All manuals and user guides at all-guides.com
The warranty for this appliance is for 3
years from the date of purchase. The ap-
.
6
between the
pliance has been manufactured with care
11
.
and meticulously examined before deliv-
7
ery. Please retain your receipt as proof
by turning the
6
of purchase. In the event of a warranty
claim, please make contact by telephone
clockwise
with our Service Department. Only in this
6
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
Cleaning
rISK OF InJUrY! Always
disconnect the device from the compressed air
source before you clean it.
Clean the air sander after you have finished
using it.
Store the air sander in dry enclosed rooms only.
Use a dry cloth to clean the device. Under no
circumstances should you use petrol, solvent or
cleaners which attack plastic.
Keep the ventilation openings clear at all times.
Remove dust clinging to the sander
with a brush.
Service centre
have your air sander
repaired only by qualified specialist
personnel using original manufacturer
parts. This will ensure that the air sander
remains safe to use.
Warranty
Capítulos
Tabla de contenido
