Idiomas disponibles
Idiomas disponibles
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm2.
Connections and repairs of electrical equipment
may only be carried out by an electrician.
Please provide the following information in the event of
any enquiries:
Type of current for the motor
• Machine data - type plate
• Machine data - type plate
13. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types of
material, such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.
14. Troubleshooting
Fault
Possible cause
Motor does not work
Motor, cable or plug defective, fuses burnt
The motor starts up
Voltage too low, coils damaged, capacitor
slowly and does not
burnt
reach operating speed.
Motor makes
Coils damaged, motor defective
excessive noise
The motor does not
Circuits in the network are overloaded (lamps,
reach its full power.
other motors, etc.)
Motor overheats easily. Overloading of the motor, insufficient cooling
of the motor
Reduced cutting power
Saw blade too small (ground too much)
when sawing
Saw cut is rough or
Saw blade dull, tooth shape not appropriate for
wavy
the material thickness
Workpiece pulls away
Excessive cutting pressure and/or saw blade
and/or splinters
not suitable for use
28
GB
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check
fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the
same circuit
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal
cooling of the motor
Readjust end stop of the saw unit
Resharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
